Sterlco Royal Series Compact Temperature Control Unit - Manual (Page 14)

Page 14 Royal Series Water Temperature Control Units
2-6 Uncrating Your New Royal Series System
Royal Series water temperature control units are shipped
fastened to a skid and covered with a cardboard box.
Carefully remove the staples on the bottom of the box, lift off
the box, and remove the bolts holding the unit to the skid.
Caution!
Be careful when cutting straps.
Straps may spring back and cause injury!
From the side, slip two lifting straps between the skid and
temperature control unit. Spread the straps from the center line
so it is balanced.
Loop the straps over a fork truck fork. Lift slowly and only
high enough to clear the skid. Use a pry bar if necessary to
remove the skid from the unit.
Carefully slide the skid from beneath the unit and lower the
unit. Lower slowly. The unit should land on its casters and can
be rolled into position.
Retain the crating in case reshipment is necessary due to
hidden shipping damage.