Sterlco SGBD Series Batch Gravimetric Blenders - Manual (Page 97)

BLN1-600 Chapter 7: Appendix 97 of 110
Customer Setup Menu
Password Protection
The Setup screen allows you to change the default User Password that the blender uses to
lock out certain screens. The password by default is “5413”. To change the password,
follow the steps listed below:
1. Set the Selected Operator to “USER” by touching the box located next to “Select
Operator”.
2. Touch “New Password” and enter in a new password.
3. Touch “Verify Password” and enter in the same password.
4. A message telling you that the password has been changed will appear.
Figure 75: Typical User Password Setup Screen
If the Customer locks themselves out of a blender they can contact the manufacturer for a
procedure that will let them back in. This password is used in several places throughout the
blender, but can be bypassed by entering in the Manufacturer’s Service Password.
Units
This screen allows the user to change the blender’s unit of measurement. The entire blender
can be configured in either Kgs. or Lbs., while the Target vs. Actual data can be configured
for either regardless of the blender’s units.
Figure 76: Typical Units Screen
1. Select “USER”
4. Back to Setup
Directory
2. Enter New
Password Here
3. Verify New
Password to
Finish
Change Target vs.
Actual Units
Change
Blender’s
Units
Go back to
Setup
Directory