Sterlco SGBD Series Batch Gravimetric Blenders - Manual (Page 93)

BLN1-600 Chapter 7: Appendix 93 of 110
7-4 Addendum (Service Supervisor Information)
After all selections are made: Keep pressing the “Done” key until the unit
returns to the Recipe menu.
Passwords
• User Password “5413”
• Maintenance Password “3145348”
Maintenance password should only be supplied to qualified personnel! The
program can be compromised.
Programmable Settings
The Slide Gate/Auger blender software program has been designed to allow some
customizing to achieve certain desired operating parameters. The following is a listing of the
selections that are “field” programmable, followed by the procedure for doing so.
This menu is accessed by pressing the manufacturer’s icon when in the “Setup” Directory
Screen menu.
Figure 67: Typical Operator Setup Screen
Enter the long password “3145348” and press “Enter”. The factory setup section displays the
“Engineering Only” screen. The screen similar to that shown below should be displayed and
use the keystrokes described herein to change or toggle the parameters.
• This section of the manual should not be used by untrained personnel –
blender controller and/or program can be compromised!
• Hidden, programmable features and hidden menu pages should not be made
available to floor operators. These pages include the Service Supervisor
Information addendum located in this section. Unauthorized changes to
these factory settings by inexperienced operators may prevent the unit from
operating properly, and may void part or all of the warranty.
• Programmable features should not be accessed by inexperienced operators
or inexperienced plant personnel. Unauthorized changes may prevent the
blender from operating properly and may void part or all of the warranty.
• Call the Service Department for assistance or for further explanation of
these or any other programmable features, which may or may not be shown
in this manual.
• Information included in this manual is subject to change without notice.
Touch this icon and
enter in the Service
Password to access
the Engineering Only
Directory