Raytec Milestone Plug-in - Manual (Page 19)

18
Raytec Global (excluding Americas) - Tel: +44 (0) 1670520055 [email protected]
Raytec Americas - Tel: +1 613 270 9990 Toll Free: +1 888 505 8335 [email protected]
www.rayteccctv.com
6.5.2 Configuring alarms from your illuminator
It is possible to configure your Milestone system to respond to events created by your
illuminators, these alarms are standard Milestone alarms and are covered in the Milestone
configuration guide.
Open the XProtect Management application
On the left hand side select the Alarms section
Right click on alarm definitions and select create new
To raise an alarm from your illuminator, select VARIO IP Lamp from the ‘Triggering Event’
drop down menu.
You can now select the specific action to create the alarm from the list just below the Vario
IP Lamp option shown above. There are currently two different actions from two devices on
the illuminator available to you
– 1) External Input Active or Inactive and 2) Photocell Day or
Night
The select button will become active at this point and you may select which individual
illuminators will raise this alarm. For further information about configuring alarms please
consult your Milestone documentation.