Raytec Milestone Plug-in - Manual (Page 17)

16
Raytec Global (excluding Americas) - Tel: +44 (0) 1670520055 [email protected]
Raytec Americas - Tel: +1 613 270 9990 Toll Free: +1 888 505 8335 [email protected]
www.rayteccctv.com
6.4.1 Group or Lamp Trigger 1 and 2
Group or Lamp Trigger 1 and Trigger 2 are configured in the same way. You can select an
event that will cause the trigger to activate by selecting the
‘select event’ button, this can be
cleared by clicking the respective x button.
Power
This is the power that you wish the illuminator to activate at. This is set by using the sliding
bar.
Lamp stays on
The selected the illuminator will stay on at the selected power until another event turns the
illuminator off or to another power level. When this option is selected the time and revert
options are disabled as they have no meaning for a permanent action.
Lamp switches off
When selecting this option, you can configure the specified period of minutes that you want
the illuminator to be on for. Once this period elapses you can choose to either turn the
illuminator off or to have it go back to the previous state it was in. This allows for greater
control of the illuminators connected to you Milestone system.
6.4.2 Group/Lamp Deter Trigger
Your VARIO IP illuminator comes with a built in deterrent feature. It provides a selection of
preset actions that can be activated that cause the illuminator to change its power output in
a known fashion. This is useful when used as a deterrent.
Deterrent stays on
The selected the illuminator will stay on in the selected deterrent mode until another event
turns the illuminator off or to another power level. When this option is selected, the time and
revert options are disabled as they have no meaning for a permanent action.
Deterrent ends after
When selecting this option the illuminator can be configured to remain in deterrent mode for
a specified period of seconds. Once this period elapses you can choose to either turn the
illuminator off or to have it go back to the previous state it was in. This allows for greater
control of the illuminators connected to your Milestone system.
Mode
The mode option allows you specify the visible light pattern of the illuminator.
Wave: The intensity of the illuminator will increase to maximum power then
decrease to minimum power and repeats.
Hi-Lo: The illuminator switches from maximum power to minimum power and
repeats.
SOS: The illuminator performs the SOS morse code pattern at full power.