Raytec Milestone Plug-in - Manual (Page 12)

11
Raytec Global (excluding Americas) - Tel: +44 (0) 1670520055 [email protected]
Raytec Americas - Tel: +1 613 270 9990 Toll Free: +1 888 505 8335 [email protected]
www.rayteccctv.com
6 Configuring Illuminators in the XProtect Management
Application
This section will give you a quick introduction to configuring your VARIO IP illuminators in
the XProtect Management Application. You should refer to the documentation provided with
your Milestone XProtect system for further information about configuring events, alarms etc.
After first discovering your illuminators on the network using the Raytec Discovery
application, you must then discover them in the Milestone system. However, before
discovering your illuminators in the Milestone system you should configure any groups
ready to associate the illuminators with.
6.1 Creating a Group
VARIO IP illuminators can be grouped together allowing you to control multiple illuminators
at the same time from an event raised from the XProtect server or the XProtect Smart
Client.
Open the XProtect Management Application
Please note: Even if you wish to configure/operate individual illuminators, they still
need to be held in a group. To configure specific illuminator settings, you simply
click on your chosen illuminator within its group.