NORD Drivesystems BU2100 - Manual (Page 29)

5 Parameter
BU 2100 GB-2213 29
Para-
meter Parameter name Recommended setting Remarks
SK 5xxE SK 180E … SK 2xxE
P545 Actual BUS value 3 According to the
function: Not available Only SK 500E … 535E
P546 Function Setpoint BUS
value According to the
function: According to the
function:
SK 54xE and SK 180E …
SK 2xxE: up to 5 setpoints
each
P547 Function BUS setpoint
2 According to the
function: Not available Only SK 500E … 535E
P548 Function BUS setpoint
3 According to the
function: Not available Only SK 500E … 535E
Info parameters
P700 Present Operating
status
Fault / Warnings / Reason for
starting disabled condition
P701 Last fault
P740 Process data BUS In
P741 Process data BUS Out
P742 Data base version
P744 Configuration Not relevant
P745 Module version Not available
P746 Module status Not available Possible values
Bit Meaning
0 Module initialised
1 Cyclical communication
2 Vacant
3 Vacant
4 Error 1
5 Error 2
6 Error 3
7 Vacant
8-15 Module number
EtherNet/IP = 23
Table of Errors
Error Meaning
3 2 1
0 0 0 No error
0 0 1 No communication
with ASIC
0 1 0 Bus Timeout
0 1 1 P513 timeout
1 0 0 IP already assigned
1 0 1 General config. error
1 1 0 No Ethernet cable
1 1 1 Communication error
P748 CANopen status Not relevant for
SK TU3 modules System bus status
Error messages
Error messages from the module - present errors or archived messages relating to the last error - can
be read out via the module parameter (P170). The error messages are lost if the module is switched
off.