Dwyer UFM - Manual (Page 15)

F - UFM
Issue 1.4 Page 15
5.1 How to enter the Pipe ID
Figure 10 shows the Enter Pipe ID screen after an initial power up.
Initially, the inches digit ( 1. 964) will blink.
Press the key to increment the inches digit ( 1 .964) in the sequence 0, 1. Press once
to increment digit, or hold key down to automatically scroll between 0 and
4.
Press the key to decrement the inches digit in the sequence 4 to 0. Press once to
decrement digit, or hold key down to automatically scroll between 4 and
0.
Press the key to move to the 0.1 inch digit (1. 9 64). The 0.1 inch digit should now
blink.
Increment the 0.1 inch digit in the sequence 0,1,2,3,4,5,6,7,8,9,0 using
the
key. Press once to increment digit or hold down to scroll
through the numeric sequence. Decrement the 0.1 inch digit in the
sequence 9,8,7,6,5,4,3,2,1,0,9 using the key. Press once to
increment digit or hold down to scroll through the numeric sequence.
Press the key to move to the 0.01 inch and 0.001 inch digits. The selected digit
should now blink. Increment or decrement the digit in an identical manner
to the 0.1 inch digit described above.
Press the
Use
Press the key to enter the Pipe ID numerical value, and move to the next screen.
and keys to scroll through the pipe materials.
To select the material and complete the setup
procedure.
V


Figure 10 Enter Pipe ID Screen (Metric)
>
>
Λ
V
Pipe material
Plastic
V Λ