Operating procedures – Dwyer UFC User Manual
Page 20

3: Operating Procedures
16
3: Operating Procedures
QUICK START
Enter data
Attach sensors
FLOW READING
Carry out any necessary calibration
How to adjust the Zero Flow Offset – Paragraph 3.3.2
How to adjust the Calibration Factor – Paragraph 3.3.3
How to adjust the Roughness Factor – Paragraph 3.3.4
How to adjust the Damping Factor – Paragraph 3.3.5
How to measure totalized flows – Paragraph 3.5
Operation with an Energy Meter – Paragraph 3.7
Configure the interfaces
Set date/time, Language
Initial instrument setup
Connect and take basic flow readings
4-20mA ON/OFF – Paragraph 3.4.1
4-20mA Calibration – Paragraph 3.4.1
Pulse ON/OFF – Paragraph 3.4.2
Pulse calibration – Paragraph 3.4.2
Alarm outputs – Paragraph 3.4.3
Data Logging
How to set up basic (manual) logging – Paragraph 4.1
How to set up auto-timed logging – Paragraph 4.2
How to download logged data – Paragraph 4.3