Blue-White FLEX-PRO A2 ProSeries Peristaltic Pump - Manual (Page 18)

Page 18 Flex-Pro
Used to manually control speed of pump.
Use UP and DOWN arrows to adjust speed while pump is running.
To select exact run speed, follow steps below.
Step 1
Press and release STOP button
Note: Mode cannot be changed while pump is in running.
Press and release SELECT RUN MODE button multiple
times until Mode 1 is selected.
Step 2
With Mode 1 selected, press and hold SELECT RUN MODE
button until ‘Speed’ icon begins flashing.
This indicates that you’ve entered Setup menu.
Step 4
Pump will now operate at your pre-configured speed.
Press and release START button to start pump.
Press and release STOP button at anytime to stop pump.
With pump operating in manual mode (Mode 1), pump speed can be changed at anytime by using UP or DOWN arrows during
operation.
Mode 1
50.0
1
Mode 1
OFF
SPEED
1 SPEED
Step 3
Current pump speed will be displayed.
To increase value, press and release UP arrow.
To decrease value, press and release DOWN arrow.
To save value, press and hold SELECT RUN MODE button
until ‘Speed’ icon stop flashing.
Mode 1
50.0
1
SPEED
Mode 1
OFF
1 SPEED
8.0 Mode 1 - Manual Operation