Blue-White FLEX-PRO A2 ProSeries Peristaltic Pump - Manual (Page 10)

Press and release
To select Run Mode
Mode 1: Manual
Mode 2: 4-20mA input
Mode 3: Frequency input
Mode 4: Pulse / Batch
Press and Hold
To configure selected Mode
Mode 0: Setup
Mode 1: Manual
Mode 2: 4-20mA input
Mode 3: Frequency input
Mode 4: Pulse / Batch
Press and release
To prime pump (60 seconds)
Press and hold
To change rotor direction
clockwise or counterclockwise
Important: Hold button down to
trigger rotor reversal
Press and release
To
in Setup mode.
To increase value while in
programming mode.
Press UP arrow to increase
pump speed (output) in Manual
mode (Mode 1).
scroll through menu options
Press and release
To Start pump.
To begin listening (reacting) to
external signals.
Press and release
To Stop pump.
Press and release
To
in Setup mode.
To scroll through pump speed
(output) and current incoming
signals in run modes:
Mode 2, Mode 3, & Mode 4
scroll through menu options
Press and release
To
in Setup mode.
To decrease value while in
programming mode.
Press DOWN arrow to
decrease pump speed (output)
in Manual mode (Mode 1).
scroll through menu options
To view amount of run time hours on currently installed tube.
START + DOWN arrow displays current pump tube timer.
Hold down START button, then press and release DOWN arrow.
Tube Life Timer
Page 10 Flex-Pro
6.0 How to Operate Flex-Pro - Control Pad
START