Badger Meter ORION Classic (CE) - Manual (Page 22)

ORION® Water Endpoints
4 . After the endpoint is mounted in the remote box enclosure, loop the endpoint wire through the strain relief tab and
through the cutout on the bottom of the enclosure . If needed, gel splice connections can be made and kept inside
the enclosure prior to mounting .
Figure 15: Endpoint wire positioning
5 . Verify that the remote box enclosure is properly positioned with the endpoint antenna up and the endpoint IR port
facing down . Secure the enclosure to the wall using customer-supplied screws .
Figure 16: Enclosure positioning
Right side strain
relief tab
Cable out of
bottom
Page 22 June 2014