Badger Meter ORION Classic (CE) - Manual (Page 21)

Installation Manual
Figure 13: Remote box enclosure mounting
2 . Place the endpoint into the ORION remote box enclosure as shown in Figure 14 . Make certain the flat side of the
endpoint is facing the back of the enclosure (toward the installer) when inserting the ORION endpoint into the
remote box enclosure . When installing, mount the endpoint antenna toward the top of the enclosure, between the
endpoint alignment brackets .
Figure 14: Endpoint orientation
NOTE: N The arrow on the back of the remote box enclosure points up, toward the top of the assembly .
3 . When mounting the remote box enclosure on a wall, mount it with the arrow pointed up (toward the sky) .
Top
IR programming opening
2 Strain relief tabs
3 Endpoint alignment brackets
1/4 " Wide slot
IR programming adapter rails
Direction indicator
Endpoint antenna
Flat side
Direction indicator
Page 21 June 2014