Revo RE8/16DVR1 - Manual (Page 61)

Digital Video Recorder
53
Highlight the box beside Motion and press the
button. You can select the cameras for which you want any reports
of motion detection.
Highlight the box beside Video Loss and press the button. You can select the cameras for which you want any
reports of lost video.
Highlight the box beside Video Blind and press the button. You can select the cameras for which you want any
reports of blind video.
Highlight the box beside Text-In and press the button. You can select the text-in devices which you want any reports
of text input.
Highlight the box beside Record Channels and press the button. You can select the cameras that you want to search
for any reports of event recorded data. The DVR will display the events (not the camera channels) that occurred and
that also are recorded on the camera channel that you selected. If you do not select a camera channel in this field, the
DVR will search events that are not associated with cameras.
You can also toggle On and Off self-diagnostic System Events as part of your search. The choices are:
 Panic Record
 Check Recording
 Check Alarm-In
 Disk Almost Full
 Disk
Bad
 Disk Temperature
 Disk S.M.A.R.T.
 Fan Error
Once you set your desired search conditions, highlight Search and press the button to display the search results in
the Event Log Search screen. Selecting Cancel exits the screen without saving the changes.
Record Table Search
< Compact View >
< Standard View >
< Expanded View >
Figure 70 — Record Table Search screen.
Recording information about video images currently displayed
on the screen displays on the recording status bar. A grey
vertical line indicates the current search position. To search
specific video, move the vertical line by using the Left or Right
arrow buttons on the front panel or by clicking the mouse on
the desired segment.
If the DVR’s time and date have been reset to a time that is
earlier than some recorded video, it is possible for the DVR to
have more than one video stream in the same time range. In
this case, the overlapping time range in the record table will
be separated by a yellow vertical line.
There are three view modes. Standard view, Expanded view
and Compact view. Standard view (default) displays combined
recording information of all camera channels currently
displayed on the screen. In the Standard view mode, selecting
the icon located at the bottom switches to the Expanded
view mode. The Expanded view displays the recording
information of each camera channel currently displayed on
the screen. Selecting the icon in the Standard view mode
switches to the Compact view mode which displays only the
toolbar. Selecting the icon in the Compact view mode
switches to the Standard view mode, and selecting the icon
in the Expanded view mode switches to the Standard view
mode.