Revo RE8/16DVR1 - Manual (Page 26)

User’s Manual
18
Network Setup
Figure 17 — Network menu.
Network
Highlight Network in the Network menu and press the
button. The Network setup screen displays. You will be
able to change the Network, LAN, DVRNS and REVO Remote settings.
Highlight the first box beside Remote Watch – bps/ips.
Press the Up and Down arrow buttons to set the Transfer
Speed from 50Kbps to 100Mbps.
Highlight the second box beside Remote Watch – bps/ips.
You can select the unit of measure for the transfer speed
between: bps and ips. Press the
button to set the transfer
speed.
Highlight the box beside Remote Watch – Quality and press
the button. You can select the Quality from: Very High,
High
, Standard and Basic. Press the button to set the
Quality.
Figure 18 — Network setup screen.
Highlight the box beside Remote Watch – Resolution and press the button. You can select the Resolution from:
High (Half D1)
and Standard (CIF). Press the button to set the Resolution.
NOTE: The higher Quality and Resolution settings require higher Transfer Speed settings. The transfer speed
you set is the maximum speed. Depending on the network environment, this speed may not be achieved.
You can limit the network bandwidth settings so that system does not consume too much network bandwidth. Highlight the
box beside Network Bandwidth Limit and press the Up and Down arrow buttons to set the desired maximum bandwidth
from 10Kbps to 100Mbps.
NOTE: When limiting the network bandwidth, the remote watch image on the PC running REVO Remote Pro
or REVO Remote might not be displayed properly.
The DVR supports two-way audio communication between a PC running REVO Remote Pro and a local system.
Highlighting the box beside Remote Audio Channel and pressing the
button allows you to select the audio channel
that sends audio to the remote site. Selecting Select From REVO Remote Pro will send audio of the channel selected
from REVO Remote Pro.
NOTE: Depending on network conditions, audio might be interrupted or out of synchronization during
transmission.
Highlight Enable SSL for Transferring Data and press the button to toggle between On and Off. When it is On, the
security of data, except video and audio transmitted for remote monitoring or remote recording can be enhanced by using
the SSL (Secure Sockets Layer) authentication. When using the SSL function, the DVR cannot be connected with a
remote program or a network keyboard which does not support the SSL function.
CAUTION: The remote connection will be disconnected temporarily after changing the SSL settings.
NOTE: While the SSL function is enabled, the network transfer speed you set may not be achieved.
This product includes software developed by the OpenSSL Project for use in the OpenSSL Toolkit
(http://www.openssl.org/).