Recording video – Revo RE8/16DVR1 User Manual
Page 56

User’s Manual
48
Full Screen
PIP
2x2
1+5
1+7
3x3
4x4
Previous Group
Next Group
OSD
Figure 66 — Mouse Display menu.
Full Screen
Selecting (Full Screen) in the Mouse Display menu and choosing the camera number button displays the selected
camera full screen. It is the same as pressing the individual camera buttons on the front panel or clicking the left mouse
button on a camera image when in one of the multiview formats (i.e., 2x2, 1+5, 1+7, 3x3 or 4x4). Clicking the left mouse
button on the screen again returns to the previous display mode.
PIP, 2x2, 1+5, 1+7, 3x3, 4x4
Selecting , ,
,
, or (PIP, 2x2, 1+5, 1+7, 3x3 or 4x4) in the Mouse Display menu displays the cameras
in the selected multiview screen mode (PIP, 2x2, 1+5, 1+7, 3x3 or 4x4). Selecting each display mode is the same as
pressing the
LAYOUT
button or scrolling the mouse wheel up and down when in one of the multiview formats (i.e.,
2x2, 1+5, 1+7, 3x3 or 4x4).
NOTE: The PIP, 1+5, and 1+7 display modes will not be supported in the search mode.
In the 1+5 or 1+7 display mode, the main channel indicates the channel displayed on the large screen
which is displayed in the top-left. You can select the camera you want to display on the main channel
screen. Select a channel on the screen and click the right mouse button to display the Camera Menu.
Selecting Go To Main swaps the selected channel with the main channel. This function is supported only in
the 1+5 and 1+7 display modes and can be activated from any of channel screens except the main channel
screen.
Previous Group, Next Group
Selecting
or
(Previous Group or Next Group) in the Mouse Display menu moves to the previous or next page.
OSD
Selecting
(OSD) in the Mouse Display menu toggles OSD On and Off.
Recording Video
Once you have installed the DVR following the instructions in Chapter 2 — Installation, it is ready to record. The DVR
will start recording based on the settings you made in the Record setup screen. See Chapter3 — Configuration.
Recycle On
or Recycle Off. The factory default is Recycle On. It does this by recording over the oldest video once
the hard disk is full. Setting the DVR to Recycle Off causes it to stop recording once the hard disk is full.