Revo RE8/16DVR1 - Manual (Page 45)

Digital Video Recorder
37
NOTE: For the Notify action, the notify item you select should be enabled in the Notification setup screen and
the DVR should be registered in the REVO Remote Pro (Remote Administration System).
Figure 53 — Video Blind Actions 2 screen.
Highlight the desired box under the PTZ heading, and press
the button. A list of PTZ presets appears. Select the preset
position for each PTZ camera, where you want PTZ cameras
to move to when the DVR detects video blind on the selected
camera’s input.
Highlight the box under the Spot Monitor heading and press
the button. A list of SPOT monitors and cameras appears.
Each SPOT monitor can be associated with a camera. The
DVR will display the associated camera on the SPOT monitor
whenever it detects video blind on the selected camera.
Text-In
Highlight Text-In in the Event menu and press the button. The Text-In setup screen appears.
Figure 54 — Text-In Settings screen.
The DVR can be set to react to text input from devices such
as ATMs (Automated Teller Machines) and POS (Point of
Sale; i.e., cash registers). This screen allows you to configure
the DVR for each text-in device.
Highlight the box under the Setup heading, and press the
button. Selecting the Setup heading changes all the parameters
excluding Port settings of all the text input channels.
NOTE: The system performance might be affected when
a large quantity of text inputs are detected from
several channels at the same time.
Figure 55 — Text-In Device screen.
Highlight the box beside Port, and press the button. Select
from None, RS232, RS485, USB-Serial (1~8) and LAN (1~16).
NOTE: If you have set the Port as None, you will not be able
to make any changes to the screen.
NOTE: When using the USB to serial text-in device, do NOT
remove the USB cable from the port while the system
is running.
NOTE: Text-in data might be lost when text-in buffer is filled
by simultaneous text-in transactions from all 16 LAN
channels.
Highlight Setup…, and press the
button. Use the ATM or POS manufacturer’s recommended settings when configuring
the RS232, RS485, USB-Serial or LAN ports.
Highlight the box beside Text-In Product, and press the button. Select your device from the list.
NOTE: The following description is for a Generic Text Device. The screen changes for different types of text
input devices, and there will be different parameter boxes for you to enter information.