Revo RE8/16DVR1 User Manual

Page 27

Digital Video Recorder

Highlight the LAN tab, and the LAN screen displays.

Figure 19 — LAN (Manual) setup screen.

Highlight the box beside Type and press the

button. You

can select the type of network configuration from: Manual,
DHCP

and ADSL (with PPPoE). Select the desired type

and press the

button.

Selecting Manual from the Type allows you to set up LAN
parameters manually.

Change the numbers by highlighting them and using the Up
and Down arrow buttons to increase or decrease the number.
The factory default LAN settings are:

Address: 192.168.1.129

Gateway:

192.168.1.254

Subnet

Mask:

255.255.255.0

NOTE: You will need to get the appropriate IP Address, Gateway and Subnet Mask from your network

administrator.

Highlight the box beside DNS Server. Press the Up and Down arrow buttons to set the IP address of the DNS server.

Highlight the Port Number Setup… box and press the button. The Port Number Setup screen appears.

NOTE: You will need to get the appropriate Port Numbers for each REVO Remote Pro and REVO Remote related

program (Admin, Callback, Watch, Search and Audio) from your network administrator.

Change the numbers by highlighting them and using the Up and Down arrow
buttons to increase or decrease the number. The factory default Port settings are:

Remote

Admin:

8200

Remote

Callback: 8201

Remote Watch:

8016

Remote

Search:

10019

Remote

Audio:

8116

NOTE: The system restarts automatically after changing the port settings.

Do NOT use the same port number for two different programs, otherwise, the DVR cannot be connected
with the PC running REVO Remote Pro or REVO Remote.

Highlight Use UPnP and press the

button to toggle between On and Off. When it is On, port forwarding from the

NAT (Network Address Translation) device to the DVR will be enabled automatically via UPnP (Universal Plug and
Play) service. This function will be used especially when accessing to a port on a private IP address.

NOTE: For the UPnP service to work, the NAT device should support the UPnP Port Forwarding function and the

function should be set to enabled.

You cannot change the port settings when Use UPnP is On.

Highlight the Status box and press the

button to display the port numbers forwarded from the NAT device via UPnP

service.

Selecting DHCP from the Type and highlighting Save button
reads the current IP address of the DVR configured by DHCP
(Dynamic Host Configuration Protocol) network.

Highlight Auto and press the button to toggle between On
and Off. When it is On, the DVR will obtain the IP address
of the DNS server automatically.

NOTE: Selecting Auto will only be enabled when the DVR

is configured for DHCP network.