Agilent Technologies E5810A - Manual (Page 138)

138 Appendix B
Using the Telnet Utility
Using the Telnet Utility
Exiting the Telnet
Utility
To exit the Telnet utility, use these Telnet commands.
„ If you want to exit without saving any changes (if any) you have
made to the configuration values, at the Telnet prompt (>) type
bye
(or) exit (or) quit.
„ If you want to save the changes you have made to the
configuration values via the Telnet utility, at the Telnet prompt (>)
type reboot.
„ To reset the E5810 to the default configuration values and
reboot the E5810, at the Telnet prompt (>) type
factory-reset
.
CAUTION
Any client operations in progress and client connections will be
terminated by the reboot command.
CAUTION
Any client operations in progress and client connections will be
terminated by the factory-reset command when it reboots the
E5810.