Checking the network, Network configuration problems summary – Agilent Technologies E5810A User Manual
Page 114
114
Chapter 4
Troubleshooting Information
Checking the Network
Checking the Network
If the E5810 is correctly installed and configured and is operational, the next
step is to check the network installation and configuration. To do this step,
you may need the help of your System Administrator. This section gives
guidelines to check your network.
Network Configuration Problems Summary
Symptom
Possible Cause(s)
Corrective Action(s)
Cannot access
E5810 Web access
(Web Server)
Improper network installation
Check network installation or contact
System Administrator
Missing or improper setup of
network addresses:
- Ethernet (MAC) Address
- IP Address
- Subnet mask
- Default gateway (router)
Try the
ping
command (type ping
from the MS-DOS
window). If this does not work, contact
your System Administrator.
Incorrect Web Browser Settings
Change Javascript Enabled, Cache
and Page Refresh, and/or Proxy
settings as required. See “
Incorrect password
Unknown or forgotten password
Use the
Preset
button to reset the
E5810 password to the factory default
setting (E5810).
Other Network
Problems
- E5810 Operation Hangs
- SICL Timeout Set to 0