KROHNE OPTISONIC 7060 EN - Manual (Page 7)

OPTISONIC 7060
Electrical & mechanical installation manual 730962.31.00 page 7 of 52
1.3.1 Danger Due to Hot, Corrosive and Explosive Gases and High Pressure
The OPTISONIC 7060 measuring system is directly integrated into gas-carrying pipelines.
The operating company shall be responsible for safe operation and for complying with
additional national and company-specific regulations.
Warning
In plants with toxic and explosive gases, high pressure or high temperatures, the OPTISONIC 7060
measuring system shall only be mounted and dismounted when the pipelines are
vented or when the plant is not working.
The same applies to repair and service work which involves opening measuring channel or
the explosion-protected measuring transducer (CONVERTER).
Note Design, manufacture and inspection of the OPTISONIC 7060 measuring system are performed
in compliance with the safety requirements set forth in the European Pressure Equipment
Directive 97/23/EC. Any relevant information has been taken into account for the particular
application as specified in the technical information questionnaire filled out by the customer
before commencing order processing.
1.3.2 Dangers Due to Heavy Loads Overhead
The OPTISONIC 7060 measuring system must be safely attached to the lifting gear when being
transported and installed.
Important
¾
Only use the hoisting gear and auxiliaries (e.g. lifting straps) suitable for the load to be lifted.
Max. load information can be found on the type plate of the hoisting gear.
¾
The eye bolts attached to the equipment are suitable for the transport of the measuring
device. However, additional loads (e.g. blind covers, filling for pressure tests) must not be
lifted and transported together with the measuring system.
¾
Never attach hoisting gear to the measuring transducer or its mounting bracket and avoid
contact between these parts and the hoisting gear.
WARNING
IMPORTANT