KROHNE OPTISONIC 7060 EN - Manual (Page 23)

OPTISONIC 7060
Electrical & mechanical installation manual 730962.31.00 page 23 of 52
3.3.3 CONVERTER alignment
The CONVERTER can be turned to a position which provides a good view on the display and good
conditions for cable routing (see Fig. 3.4). A stop on the housing prevents the CONVERTER from
being turned more than 330 . This aims to protect the cables from the meter body from
damage.
Fig. 3.4: Positioning the CONVERTER
1. Loosen the Allen screw, use 3 mm Allen key
2. Position the converter housing
3. Tighten the Allen screw
Note Do not forget to tighten the Allan screw after positioning the CONVERTER.