KROHNE OPTISYS CL 1100 EN - Manual (Page 12)

3
INSTALLATION
12
OPTISYS CL 1100
www.krohne.com 01/2013 - 4002492301 - MA OPTISYS CL 1100 R02 en
3.3 Installing the sensor
3.3.1 Mounting to OPTISYS CL 1100 measuring system
The measuring system is delivered ready-to-use. It can be mounted in a distance of 20 mm /
0.79" to a wall via 4 predrilled holes.
Water connection
Connect the water inlet on the left side and the outlet on the right side of the flow cell. The outlet
can be an open outlet (pressureless) or the water can be re-directed into a pipe or basin.
3.4 Examples of a typical measuring point
The following drawing show an example of a typical measuring point consisting of a sensor and
the flow-through holder.
CAUTION!
Install the device at a place where mechanical and chemical stress is limited.
Mind the ingress ptotection: IP 65 (with closed terminal cover)
CAUTION!
The sensors are delivered with protective caps, which have to be removed before mounting into
the flow cell.
Figure 3-2: Measuring point using the flow cell of the OPTISYS CL 1100 measuring system
1 Inlet
2 Inlet valve
3 Flow cell of the OPTISYS CL 1100 measuring system
4 Sensor with connection to signal converter
5 Outlet valve
6 Outlet
7 Sample outlet