KROHNE OPTISYS CL 1100 EN - Manual (Page 11)

INSTALLATION
3
11
OPTISYS CL 1100
www.krohne.com 01/2013 - 4002492301 - MA OPTISYS CL 1100 R02 en
3.1 Notes on installation
3.2 Pre-installation requirements
Unpacking the sensor
• Loosen the storage cap which is screwed on to the plastic tube 1.
• Gently pull the sensor out of the plastic tube 2.
• Lay the sensor on a soft mat/tissue 3.
• Screw the provided sealing cap on to the plastic tube, using O-ring and washer as pictured in
the drawing 4. Keep the storage cap (the one with the hole in it) in the original packing.
INFORMATION!
Inspect the cartons carefully for damages or signs of rough handling. Report damage to the
carrier and to the local office of the manufacturer.
INFORMATION!
Do a check of the packing list to make sure that you have all the elements given in the order.
INFORMATION!
Look at the device nameplate to ensure that the device is delivered according to your order.
Check for the correct supply voltage printed on the nameplate.
CAUTION!
• Do not touch or scratch the gold electrodes of the sensor.
• Make sure that the gold electrodes are clean and dust-free. If necessary, clean the tip as
described on page 33
.
Figure 3-1: Handling the sensor