Jenway 73 Series PC software - Manual (Page 53)

53
7.1.2 Setting the wavelength
To select the wavelength that
the zero calibration and
sample measurements will be
performed at type the
wavelength into the text box.
The wavelength selected
should be the same
wavelength that the standards
were or will be measured at. If
a value entered is outside of
the range of the instrument an
error icon will be displayed and
this must be corrected before
the settings screen can be
exited. Only numeric values
can be entered.
7.1.3 Selecting kinetics run time
To select the time for the kinetics
run type the time in seconds into
the text box.
Only numeric values can be
entered.