Jenway 73 Series PC software - Manual (Page 48)

48
To continue click Yes, to cancel click No or Cancel.
If the wavelength is changed then the zero calibration must be performed again before a sample can
be measured. The standard samples should also be re-measured at the new wavelength.
Alternatively a new quantitation tab can be opened and the required settings can be entered and a
new quantitation curve can be created.
6.4 SAMPLE MEASUREMENT
Insert the cuvette containing
the unknown sample into the
sample chamber and close
the instrument lid.
Click on the Read button; the
instrument performs the
measurement and result is
displayed on the screen.
If the same sample needs to
be measured more than
once click on the Auto Log
button.
The instrument will perform
the required number of
readings with the specified
time interval between each
measurement as set in the
Settings screen.
The results will be displayed on the screen. The batch name entered in the settings screen will have
01, 02 etc after the name, to signify the order in which the results were generated.
Auto logging can be stopped before all the measurements have been completed by clicking on the
Stop button. To recommence auto logging click on the Auto Log button again.