Jenway 73 Series PC software - Manual (Page 13)

13
3.1 Settings
To set the measurement parameters click on the Settings button.
This screen allows the batch
name, wavelength and resolution
to be set. If Auto Logging is
required the parameters can be set
in this screen. Comments can be
entered which will be included on
the result printouts.
Once the required measurement
parameters have been entered
click on the OK button to accept
and continue with calibration and sample measurement. To exit the settings without saving any
measurement parameters click on the Cancel button. To save the measurement parameters for future
use click on the Save button. To load previously saved measurement parameters click the Open
button. For more details on saving and opening method parameters refer to section 8.
3.1.1 Batch name
The batch name entered here
will be reflected on the name tab
at the bottom of the screen and
under sample name in the
results table once results have
been generated.