Jenway 73 Series PC software User Manual
Page 26
26
Click on the Standard button.
The instrument will take a
reading and calibrate to the
standard
concentration.
Once
the
calibration
is
complete the Read and Auto
Log buttons are active and
the
sample
can
be
measured.
If the settings menu is re-entered following the standard calibration it is possible to change the
wavelength. However a warning will be displayed to warn that critical settings are being changed after
the zero calibration has been performed.
To continue click Yes, to cancel click No or Cancel.
If the wavelength is changed then the zero and standard calibration must be performed again at the
new wavelength, before a sample can be measured. Alternatively a new concentration tab can be
opened and the required settings can be entered.