In-Situ smarTROLL Multiparameter Handheld Operators Manual - Manual (Page 6)

6
Introduction
This manual is intended to describe the characteristics, operation, calibration, and
maintenance of the SmarTROLL™ MP Instrument.
Scope
This manual covers the following information.
Chapter 1—Introduction
Chapter 2—Safety
Chapter 3—Overview
Chapter 4—System Components
Chapter 5—Probe Setup
Chapter 6—iSitu Overview
Chapter 7—iSitu Sites
Chapter 8—iSitu Data
Chapter 9—iSitu Sensor Calibration
Chapter 10—Low-Flow Pump Testing
Chapter 11—Care and Maintenance
Serial Number Location
The probe serial number is on the product label affixed to the probe body.
The battery pack serial number is on a sticker affixed to the battery pack casing.
Safety
l
Do not submerge the battery pack or the mobile display device in liquid.
l
Ensure that the pH/ORP sensor is completely inserted into the port, so that no
liquid can enter the instrument. The storage plug is not intended to be used when
the instrument is deployed in water.
l
Ensure that the RDO Sensor Cap is pressed firmly over the sensor lens and is
flush with the instrument before submerging in liquid.
l
Replace the cable if insulation or connectors are damaged.
l
Make sure the probe and sensor O-rings are clean and free of damage.