Ampro Corporation Single Board Computer 700 User Manual
Page 74
Chapter 4
BIOS Setup
68
Reference Manual
ReadyBoard 700
♦
Assign IRQ 11 – [Disabled] or [Enabled] (Typically ISA Bridge/Native IDE)
•
If this field is set to [Enabled], then the BIOS can assign this IRQ to a Plug and Play
adapter.
•
If another device in the system is using this IRQ, then this field should be set to
[Disabled].
♦
Assign IRQ 12 – [Disabled] or [Enabled] (Typically PS/2 Mouse)
•
If this field is set to [Enabled], then the BIOS can assign this IRQ to a Plug and Play
adapter.
•
If another device in the system is using this IRQ, then this field should be set to
[Disabled].
♦
Assign IRQ 14 – [Disabled] or [Enabled] (Typically Hard Disk)
•
If this field is set to [Enabled], then the BIOS can assign this IRQ to a Plug and Play
adapter.
•
If another device in the system is using this IRQ, then this field should be set to
[Disabled].
♦
Assign IRQ 15 – [Disabled] or [Enabled] (Typically Hard Disk)
•
If this field is set to [Enabled], then the BIOS can assign this IRQ to a Plug and Play
adapter.
•
If another device in the system is using this IRQ, then this field should be set to
[Disabled].
♦
Assign DMA 0 – [Disabled] or [Enabled]
•
If this field is set to [Enabled], then the BIOS can assign this DMA channel to a Plug and
Play adapter.
•
If another device in the system is using this DMA channel, then this field should be set to
[Disabled].
♦
Assign DMA 1 – [Disabled] or [Enabled]
•
If this field is set to [Enabled], then the BIOS can assign this DMA channel to a Plug and
Play adapter.
•
If another device in the system is using this DMA channel, then this field should be set to
[Disabled].
♦
Assign DMA 2 – [Disabled] or [Enabled]
•
If this field is set to [Enabled], then the BIOS can assign this DMA channel to a Plug and
Play adapter.
•
If another device in the system is using this DMA channel, then this field should be set to
[Disabled].
♦
Assign DMA 3 – [Disabled] or [Enabled]
•
If this field is set to [Enabled], then the BIOS can assign this DMA channel to a Plug and
Play adapter.
•
If another device in the system is using this DMA channel, then this field should be set to
[Disabled].