Ampro Corporation Single Board Computer 700 - Manual (Page 7)

ReadyBoard 700 Reference Manual 1
Chapter 1 About This Manual
Purpose of this Manual
This manual is for designers of systems based on the ReadyBoard™ 700 single board computer (SBC).
This manual contains information that permits designers to create an embedded system based on specific
design requirements.
Information provided in this reference manual includes:
•
ReadyBoard 700 Specifications
•
Environmental requirements
•
Major integrated circuits (chips) and features implemented
•
ReadyBoard 700 connector/pin numbers and definition
•
BIOS Setup information
Information not provided in this reference manual includes:
•
Detailed chip specifications
•
Internal component operation
•
Internal registers or signal operations
•
Bus or signal timing for industry standard busses and signals
Reference Material
The following list of reference materials may be helpful for you to complete your design successfully.
Most of this reference material is also available on the Ampro web site in the Embedded Design
Resource Center. The Embedded Design Resource Center was created for embedded system developers
to share Ampro’s knowledge, insight, and expertise gained from years of experience.
Specifications
•
EPIC Specification Revision 1.1, July 16, 2004
Web site: http://www.epic-sbc.org/images/pdfs/EPICspec.pdf
•
PC/104 Specification Revision 2.5, November 2003
•
PC/104-Plus Specification Revision 2.0, November 2003
For latest revision of the PC/104 specifications, contact the PC/104 Consortium, at:
Web site: http://www.pc104.org
•
PCI 2.2 Compliant Specifications
For latest revision of the PCI specifications, contact the PCI Special Interest Group Office at:
Web site: http://www.pcisig.com