Ampro Corporation Single Board Computer 700 - Manual (Page 32)

Chapter 3 Hardware
26 Reference Manual ReadyBoard 700
Pin # Signal Input/
Output Description
76 (C16) GND Digital Ground
77 (C17) AD22 T/S PCI Address and Data Bus Line 22 – Refer to Pin-3 for more
information.
78 (C18) IDSEL1 Initialization Device Select 1 – Refer to Pin-18 for more
information
79 (C19) VI/O NC (+5V) Not connected
80 (C20) AD25 T/S PCI Address and Data Bus Line 25 – Refer to Pin-3 for more
information.
81 (C21) AD28 T/S PCI Address and Data Bus Line 28 – Refer to Pin-3 for more
information.
82 (C22) GND Digital Ground
83 (C23) REQ1* T/S Bus Request 1 – Refer to Pin-23 for more information.
84 (C24) +5V +5 volt power supply ±5%
85 (C25) GNT2* T/S Grant 2 – Refer to Pin-25 for more information
86 (C26) GND Digital Ground
87 (C27) CLK3 In PCI clock 3 – Refer to Pin-27 for more information
88 (C28) +5V +5 volt power supply ±5%
89 (C29) INTB* O/D Interrupt B – This signal is used to request interrupts only for
multi-function devices.
90 (C30) PME* Power Management Event – This signal is used for power
management events
91 (D1) AD00
T/S
PCI Address and Data Bus Line 0 – Refer to Pin-3 for more
information.
92 (D2) +5V +5 volt power supply ±5%
93 (D3) AD03 T/S PCI Address and Data Bus Lines 3 – Refer to Pin-3 for more
information.
94 (D4) AD06 T/S PCI Address and Data Bus Lines 6 – Refer to Pin-3 for more
information.
95 (D5) GND Digital Ground
96 (D6) GND Digital Ground
97 (D7) AD12 T/S PCI Address and Data Bus Line 12 – Refer to Pin-3 for more
information.
98 (D8) +3.3V +3.3 volt power supply ±5%
99 (D9) PAR T/S PCI bus Parity bit – This signal is the even parity bit on AD[31:0]
and C/BE[3:0]*
100 (D10) SDONE NC Snoop Done – Not connected
101 (D11) GND Digital Ground
102 (D12) DEVSEL* S/T/S Device Select – This signal is driven by the target device when its
address is decoded.
103 (D13) +3.3V +3.3 volt power supply ±5%
104 (D14) C/BE2* PCI Bus Command/Byte Enable 2 – Refer to Pin-4 for more
information.
105 (D15) GND Digital Ground