GW Instek GDM-8261A Remote Viewer(DMM-Viewer) Guide - Manual (Page 7)

SETUP
7
S
ETUP
Connection
When using DMM Viewer in Conjunction with the GDM-8261(A), use the
following instructions to set the DMM to RS232 or USB mode each time the
DMM is turned on.
NOTE: If you are using DMM Viewer in software demonstration mode (no
hardware) skip the Connection and Configuration procedure and install the
DMM Viewer software, page 10.
Note
The following procedure describes a USB
connection configuration and procedure. Skip
this step if connecting with an RS232 cable.
1. Configure the
DMM for USB 1. Press the Shift key, the 2 ND
(Menu) key, then the Left key
until the I/O configuration
menu appears.
2ND
MENU
2. Press the Down key then
press the Left key until the
USB selection display
appears.
3. Press the Down key. The
USB ON/OFF selection
appears.