GW Instek GDM-8261A Remote Viewer(DMM-Viewer) Guide - Manual (Page 20)

GDM-8261(A) Remote Viewer Guide
20
P
LOT GRAPH/ SAVE
To be able to plot data, it must first be saved. Once data is retrieved, the
measurement data can be viewed in graph mode or used in a spreadsheet.
This section shows how to store the data and view it (offline) using the graph
function.
Store data To store data, click the START button and then key in
the log file name in the Input Name dialog box before
starting your measurements.
You can only plot data after it has been saved first!
The following instructions must be made every time
you wish to save data.
1. After you click the START button,
your measurements will be recorded
into the DMM VIEWER program
directory with the file name that you
typed in the Input Name dialog box.
2. Type in the file name (no file
extensions are needed)from the
pop-up window and click OK
The file will be saved in the directory where the viewer
software is installed.
3. Wait for the Test Time to finish or
click the START button again to
finish.