beautypg.com

Configuration – GW Instek GDM-8261A Remote Viewer(DMM-Viewer) Guide User Manual

Page 14

background image

GDM-8261(A) Remote Viewer Guide

14

Configuration

1. Configure the
PC

1. To make sure the DMM is recognized by the PC,

open the Device Manager (Start > Control
Panel > (System) > Device Manager
. If using
USB, the USB driver, GDM8261(A) CDC, should
be listed in the Ports section.

2. Check which COM port the USB driver/RS232

connection is assigned to.

3. Please note the COM port number for the PC

connection.

2. Configure DMM
Viewer

1. Activate DMM Viewer.

2. Click on the Setting(O)

menu and open the settings
dialog. Enter the default
settings as detailed below. For
more information on
configuring Sample Rate and
Recording, see the
measurement chapter on
page 16.

COM PORT: according to the Device Manager

Baud Rate: 115200 (Or the baud rate set above)

3. Click on the Connect button. The viewer software

and the GDM-8261(A) will try to establish a
connection (success), or an error message appears
(fail). If the connection is successful, a pop-up
message will return the model type, serial number
and firmware version.