GW Instek GDM-8261A Remote Viewer(DMM-Viewer) Guide - Manual (Page 17)

MEASUREMENT
17
Data field
4. Stop
measurement Click on the START button again to stop the
measurement. The button color changes from red to
black.
START key
Configuration 1. In the middle of the DMM Viewer main window,
the Test Speed and Test Time are selectable as
shown in the fields marked inside the red frame
below.
Test Speed 2. In the Test Speed drop down selection menu
choose the sample rate in milliseconds, from
16.667ms to 60000ms.
Test Time 3. Choose the duration of the measurement (in
minutes) from the Test Time drop down selection
menu. You can choose from continuous or .5 to
1440 minutes. Measurements will cease after the
allotted time has elapsed from when the Start
button is pressed.
If Continuous is selected then the measurements
will continue until the Start button is pressed again.