GW Instek GDM-8261A Remote Viewer(DMM-Viewer) Guide - Manual (Page 10)

GDM-8261(A) Remote Viewer Guide
10
Installation
Two items, the USB driver and DMM Viewer Software need to be installed
onto the PC in order to run the software properly.
Make sure the USB driver is installed first onto the PC if using USB.
1. Accessing the
CD-ROM Open the CD-ROM menu. For details, see page 5.
2. Installing the
USB driver If using RS232 rather than a USB connection,
this section (Installing the USB driver) may be
skipped.
1. Click on the Install USB Driver icon.
2. The USB driver file, USB_Driver.inf is shown in
the file explorer.
3. Configure the GDM-8261(A) I/O to
USB=ON.
Page 7
4. Connect the USB cable from the GDM-8261(A)
rear panel USB port to the host PC.
5. The GDM-8261(A) will be recognized as new
hardware. Follow the Windows Installation Wizard
to install the USB driver (USB_Driver.inf) from the
CD.
Note
The PC may need to be restarted once the driver is
installed.
3. Installing DMM
Viewer 1. Click on the DMM-Viewer icon.
2. Click on the Install DMM-Viewer icon.