GW Instek PSP Series - Manual (Page 4)

PSP SERIES
USER MANUAL
2
-Thunderstorms or storm conditions such as strong electrostatic fields,
etc.
Any use other than above description may leads to damage to the unit;
or causes dangers such as short circuit, fire, electric shock, etc. No part
of the product may be modified or converted. The safety instructions are
to be followed without fail.
PSP SERIES
USER MANUAL
3
2. Safety Information
Note: Damage caused by failure to observe the operating
instructions voids the guarantee.
We accept no liability for consequential damage and accept no responsibility
for damage to property or injury to persons caused by improper operation
or failure to observe the safety instructions. Such cases void the guarantee.
a) Installation and handling safety instructions
Observe the following rules when installing the instrument:
a1. Avoid use the instrument in extremely cold or hot locations or
directly adjacent to a heating fan.
a2. Never switch the instrument on immediately when it is brought
from a cold environment into a warm room until the instrument
comes to room temperature as under the adverse conditions, the
resultant condensation may destroy the instrument.
a3. Ensure there is proper ventilation for the vents in the case (front left
side and cooling fan on the rear) to prevent heat build-up from
damaging the instrument.
a4. Never operate the instrument near hot soldering irons.
a5. Do not place the Power Supply with its front panel down to avoid
damaging the operating controls.
b) General safety requirements
The Switching Power Supply PSP series has been fully inspected and
tested with technically safe condition before shipping from the factory.
To maintain this condition and to ensure safe operation, it is essential
for the user to observe the safety instructions and warning notes which