GW Instek PSP Series - Manual (Page 21)

PSP SERIES
USER MANUAL
36
sent to the power supply, the wheel knob status will become Fine.
*KN
Function:
Set the wheel knob to Normal status.
Syntax:
KF HEX = 4B 4E 0D
Explain:
When the message of KN is sent to the power supply from
computer, the power supply will set the wheel knob to Normal status
immediately.
Example:
The present wheel knob status is at Fine, the KN message is sent
to the power supply, the wheel knob status will become Normal.
*KO
Function:
Set the Relay status to Invert.
Syntax:
KO HEX = 4B 4F 0D
Explain:
When the message of KO is sent to the power supply from
computer, the power supply will invert the relay status immediately.
Example:
The present relay status is at OFF, the KO message is sent to the
power supply, the relay status will become ON, send the message
again will become OFF.
PSP SERIES
USER MANUAL
37
*KOE
Function:
Set the Relay status to ON.
Syntax:
KOE HEX = 4B 4F 45 0D
Explain:
When the message of KOE is sent to the power supply from
computer, whatever the relay status is, the relay of power supply will
be set to ON immediately.
*KOD
Function:
Set the Relay status to OFF.
Syntax:
KOD HEX = 4B 4F 44 0D
Explain:
When the message of KOD is sent to the power supply from
computer, whatever the relay status is, the relay of power supply will
be set to OFF immediately.
*EEP
Function:
Save the present status to the EEPROM.
Syntax:
EEP HEX = 45 45 50 0D
Explain:
When the message of EEP is sent to the power supply from
computer, the power supply will be save the present setting value to
EEPROM immediately.