GW Instek AFG-100/200 Series Quick Start Guide - Manual (Page 9)

ARB Waveform
The following will describe how to create and output
an arbitrary waveform.
1. Select the output channel by pressing Signal 1
Setup or Signal 2 Setup.
2. Press ARB from the bottom menu. Press ARB on
the side menu and toggle ARB On.
3. Press Edit.
4. Press Edit Method and select the method to edit
the arbitrary waveform.
 Point/Line: Creates pulses of a user-defined
length and amplitude.
 Diagonal: Creates a diagonal line between
Addr1/Data1 and Addr2/Data2.
 Scale: Scales the ARB waveform between
0.1X ~ 10X.
 Copy /Paste: Copies a section of the ARB
waveform and pastes it to a section of the
ARB waveform.
5. Press Action to edit the ARB waveform using the
method selected above.
6. Press Output Confirm from the side menu. Set the
area of the ARB waveform to output. Press
Confirm to confirm the area to output.
7. Press more 1 of 2 and set the Frequency, Amplitude,
Offset and Rate of the ARB waveform.