GW Instek AFG-100/200 Series Quick Start Guide - Manual (Page 4)

Front & Rear Panel
Front
GND CH1 Output
Power Supply
Status LEDs
CH2 Output
SYNC Output
Positive Output Negative Output

 
 
  

V V V


WP
Power Supply
Status LEDs Indicates the state of the power
supply (AFG-125P/225P only).
Negative Output Negative output port.
GND Ground port
Positive Output Positive output port
SYNC Ouput Sync signal output. Outputs a Sync
signal, Sweep marker, Burst
marker,or Arbitrary waveform
marker signal.
CH1 Output Signal 1 output.
CH2 Output Signal 2 output.
Front
 MX
 V
INPUT
Vent USB Device Port Input Power
Vent Cooling vent.
USB Device Port The USB Device port is used to
supply power as well as
communication from the GDS-2000A
Input Power A 5V 2A power brick can be used to
power the AFG-225.