GW Instek AFG-100/200 Series Quick Start Guide - Manual (Page 11)

Burst Modulation
The following will describe how to create a burst
waveform.
1. Press Burst from the bottom menu. Press Burst on
the side menu and toggle Burst On.
2. Press N Cycle set the burst parameters.
3. Choose Infinite for an infinite number of burst
cycles or press Cycle to set the number of burst
cycles for each period.
4. Press Phase to set the phase of the burst.
5. Press Period to set the period of each burst cycle in
seconds (not for infinite).
6. Press TRIG Set to set the trigger settings: INT,
Manual Trigger and Delay.
Turn the Output Signal On
The following will describe how to turn the output
signal on and how to set some basic output
parameters.
1. Press Go Back on the bottom menu to return to
first level of the AFG menu.
2. Press Output Setup.
3. Press Select and choose the output signal channel.
4. Press Output and toggle the selected output On.
 The signal will now be output.