Edwards Signaling 2453BSA User Manual

Page 2

Indoor Bell/Strobe Adapter Plate,

403-3A-R

30 cd, Red

XLS403-3A-R
2453BSA-30-R
BS-3AR

Indoor Bell/Strobe Adapter Plate,

403-5A-R

15 cd, Red

XLS403-5A-R
BS-5AR

Indoor Bell/Strobe Adapter Plate,

403-7A-R

15/75 cd, Red

XLS403-7A-R
2453BSA-15/75-R
BS-7AR

Indoor Bell/Strobe Adapter Plate,

403-8A-R

110 cd, Red

XLS403-8A-R
2453BSA-110-R
BS-8AR

Operating Voltage

20-24V DC

Operating Current

See Figure 3

Flash Rate (per second)

1 fps (synchronized)

5A*

Light Output (cd)

UL 1971

30 cd wall

15 cd

15 cd wall

110 cd wall

UL 1638

30 cd

not rated

75 cd

120 cd

ULC S526

30 cd

15 cd

75 cd

120 cd

Operating Environment

Indoor 93% relative humidity @ 86F (30C), 32F to 120F (0C to

49C) variable ambient temperature

*The 5A model is for wall mount use only.
NOTE: This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause
harmful intereference to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the user will be required to correct
the interference at his own expense.
CAUTION: Changes or modifications to this equipment not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.

Same Signal Circuit
The bell and strobe can be connected to the same
signal circuit (as shown) if the circuit is configured for
continuous signal operation.
Caution: Electrical supervision requires wire run to be
broken at each device. Do not loop signal circuit field
wires around the Bell/Strobe unit leads.

Separate Signal Circuits
The bell and strobe can be connected to different
signal circuits (as shown). The strobe is designed to
be used on circuits that output a constant voltage. Do
not connect the strobe to a coded or pulsating voltage.
Caution: Electrical supervision requires wire run to be
broken at each device. Do not loop signal circuit field
wires around the Bell/Strobe unit leads.

Figure 2. Connecting Strobe Unit

Table 1. Specifications

Table 2. Bell/Strobe Adapter Plates