Edwards Signaling 105 Series - Manual (Page 2)

P/N 3100290 ISSUE 3
Strobe tube
Strobe tube base
Strobe tube
socket
105-L Series
Lens
Beacon Base
Gasket
Adhesive backed
gasket
105PM Pipe Mount
Attachment
3/4" (19 mm) conduit
nipple
Figure 2. Securing the Beacon to the Mounting
Attachment
(Pipe Mount Attachment shown)
CAUTION
Do not touch the strobe tube or halogen bulb with
bare fingers. Grasp the light source either by the
base or using a soft, clean cloth.
Figure 1. Mounting Cat. No. 105BM Mounting
Bracket
105-L Series
Lens
(4) Countersunk screws
to mount lens to 105BM
(supplied)
Gasket
Adhesive backed
gasket
105BM Mounting
Bracket
(4) Screws to mount
105BM to 105BX
(supplied)
Adhesive backed
gasket
(2) Screws to mount
105BX to the
mounting surface
Mounting
Surface
the gasket with the mounting holes in the outlet
box.
NOTE: It is not necessary to remove the lens from the
Hi-Intensity Strobe Base to install the 105HIST
series beacons.
4. Mount 105SLED, 105FLED, 105SINH, 105FINH, and 105ST
Series as follows. Unscrew the gasketed base from the
lens assembly as shown in Figure 2 and remove the
clear gasket from around the base.
5. Secure the base to the appropriate mounting
attachment using four screws (supplied). Replace the
clear gasket on the base with the flared, open end
facing down.
6. Attach the unit's wire leads to the field wiring as shown
in Figure 4.
7. Ensuring that the light source is in place, screw the
lens back on the base.
8. Mount the 105HIST Series as follows. Secure the
hi-intensity strobe base to the appropriate mounting
attachment using four screws (supplied) as shown in
Figure 3.
9. Apply power and verify operability.
Maintenance
WARNING
To prevent electrical shock, before starting work on
units disconnect power and, for strobe modules
wait 5 minutes for stored energy to dissipate.
The lens should be periodically cleaned using a mild de-
tergent and water on a soft, clean, lint-free cloth.
Light Source Replacement
1. Unscrew the lens from the base.
2. For Halogen Bulb Replacement:
a. While pressing down on the bulb, turn and then
pull straight up and out of the socket.
b. Insert the new halogen bulb into the socket, press
down and turn until the bulb is locked into place.
3. For Strobe Tube Replacement:
a. Grasp the strobe tube by its base and pull straight
up out of the strobe tube socket (Figure 2).
b. Grasp the new strobe tube by the strobe tube base
and press into the strobe tube socket.
4. Screw the lens onto the base.
5. Apply power and verify operability.