Edwards Signaling 101 Series - Manual (Page 5)

P-047550-1297 ISSUE 6
Figure 5. Stacking the Modules on AdaptaLight
Base Unit
Table 2. Specifications
Figure 4. Wiring to the Terminal Block
Lamp Light Replacement Replacement
Catalog Number Voltage Current Sound Output Life Output Horn Lamp**
101BS-N5 120V 50/60 Hz 0.05A 85 dB at 10 ft. (3.05 m) -- __ 123A-N5 --
101BS-E1 12V DC 122-E1
101BS-G1 24V DC 122-G1
101SINH*-N5 120V 50/60 Hz 0.11A -- 25,000 hr. † 70 lumens # -- 50LMP-12WH-D***
101SIN*-E1 12V DC 1.0A 1,520 hr. † 189 lumens # Ind. Trade 94
101SINH*-G1 24V DC 0.32A 15,000 hr. † 52 lumens # 50LMP-9WH-D***
101SLED*-N5 120V 50/60 Hz 0.022A -- 100,000 hr. † -- -- --
101SLED*-G1 24V DC 0.062A
101FINH*-N5 120V 50/60 Hz 0.11A -- 25,000 hr. † 70 lumens # -- 50LMP-12WH-D***
101FIN*-E1 12V DC 0.10A 1,520 hr. † 189 lumens # Ind. Trade 94
101FINH*-G1 24V DC 0.32A 15,000 hr. † 52 lumens # 50LMP-9WH-D***
101FLED*-N5 120V 50/60 Hz 0.022A -- 100,000 hr. † --
101FLED*-G1 24V DC 0.062A
101ST*-N5 120V 50/60 Hz 0.12A -- 3,000 hr. ‡ 300,000 -- 91B-ST
101ST*-E1 12V DC 0.5A peak candela
101ST*-G1 24V DC 0.3A
*Letter in this position specifies lens and LED color: A - amber, B - blue, C - clear, G - green, M - magenta, R - red.
NOTE: LED modules are only available in amber, blue, green and red.
**The LED modules are permanently installed.
***A non-halogen bulb may be used in place of the halogen bulb as follows. For 120V models, use Lamp Industry Trade No. 15T7DC and for 24V DC models, use
Lamp Industry Trade No. 1692.
† Projected lamp life based on manufacturer's calculated lamp life @ 65 fpm and 50% duty cycle.
‡ Calculated strobe tube life at operating power to 75% efficiency.
# Manufacturer's lumen rating.
f. On DC models, connect the wires from the horn to the
terminal block. On AC models, connect wires using wire
nuts (not supplied).
Cleaning
The AdaptaLight module lens surfaces should be periodically
dusted and cleaned with a dry soft clean cloth to maintain opti-
mum light visibility. If necessary, the outer lenses may be cleaned
with water and a mild detergent on a well rung out soft clean
cloth.