Edwards Signaling 5553 Series - Manual (Page 4)

Speaker
Large star nut to
adjust speaker
direction
Signal Box
(4) Cover
screws
(4) Collar
gaskets
Raceway and connections
(not supplied) to
1/2" (12.7 mm) knockout
hole
(4) #10 x 3" (76 mm)
screws or other hardware
suitable for the mounting surface
Figure 2. Adaptatone Mounting
7. To adjust speaker direction, loosen large star nut (Figure 3) and
turn speaker to the approximate desired position.
To ensure integrity of the Adaptatone assembly when
adjusting the speaker direction, make sure threads in the
enclosure remain fully engaged and do not turn speaker more
than 360 degrees from the original factory installed position.
High volume may cause harm to personnel in close proximity.
9. Verify operability.
Maintenance and Test
Examine the unit semi-annually for accumulation of dirt. Clean if
necessary.
The Adaptatone should be tested annually or as required by the author-
ity having jurisdiction to ensure continuous service.
Ensure that power is disconnected before cleaning inside of
unit.
WARNING
WARNING
WARNING
8. Regardless of speaker direction adjustment, it is important that the
star nut be tightened wrench tight to ensure the speaker position
is maintained securely.
Figure 3. Wiring a Single 5553 Series Speaker (non supervised)
1 5W 25V * .9W 70V
1.8W 7 0V
0.48W 2 5V 7.5W 70V
15W 7 0V
7. 5W 25V *
1 .8W 25V
0.94 W 25V
3.8W 70 V
* DO NOT US E
FOR 70V
+
AUDIO IN PUT CONNECTION S
From Amplifier
+
_
1/2" Conduit Entries
Power Tap
Selection Switch
(See table 1)
+
_
P/N 3101297 ISSUE 0 2
PAGE 3