Detcon PI-700 User Manual
Page 38
Model PI-700
PI-700 Instruction Manual
Rev. 2.5
Page 34 of 54
Reassembly
1. Install the lamp into the sensor, making sure that the lamp’s metalized pads are aligned with the
corresponding excitation springs inside the lamp cavity
Figure 24 Lamp installation
2. With the end of the clean tweezers, or a clean blade of a screwdriver, press down firmly, being careful not
to scratch the surface of the lamp.
Figure 25 Lamp seating
3. Using fine tipped tweezers, install the cell assembly. Align the pins with the corresponding sockets on the
sensor and push down on the end with the pins. Make sure the cell assembly is flush with the lamp
window.
Figure 26 Cell Assembly installation
See also other documents in the category Detcon Sensors:
- TP-700 (48 pages)
- TP-700 SIL 2 Safety Manual (6 pages)
- FP-700 (50 pages)
- FP-700 SIL 2 Safety Manual (6 pages)
- IR-700 (50 pages)
- IR-700 SIL 2 Safety Manual (6 pages)
- DM-700 (58 pages)
- DM-700 SIL 2 Safety Manual (6 pages)
- PI-700 0-500ppb (59 pages)
- DM-634 (21 pages)
- PI-600 (37 pages)
- DM-600IS (41 pages)
- IR-640 (24 pages)
- IR-622 (24 pages)
- FP-624D-HT (48 pages)
- FP-524HT (22 pages)
- FP-624D (46 pages)
- FP-624C (26 pages)
- TP-624D (44 pages)
- TP-624C (25 pages)
- TP-524D-HRT (52 pages)
- TP-524D (40 pages)
- TP-524C (20 pages)
- FP-524D-HRT (52 pages)
- FP-524D Quick Start Guide (2 pages)
- FP-524D INSTRUCTION MANUAL (43 pages)
- FP-524C (21 pages)
- PI-500 (31 pages)
- TP-424C (15 pages)
- DM-200 (50 pages)
- DM-100 (44 pages)
- FP-100 (34 pages)
- SG1 (16 pages)
- DM-534C (22 pages)
- IR-540 (19 pages)
- IR-522 (19 pages)
- DM-434B (11 pages)
- DM-400IS (22 pages)
- FP-424C (15 pages)