Triton RT2000 X2 Installation Manual - Manual (Page 28)

28
M
ODEL
RT2000 (X2) I
NSTALLATION
G
UIDE
TCP/IP (E
THERNET
)
7KH (WKHUQHW RSWLRQ PDNHV \RXU 57 $70 /$1 /RFDO $UHD 1HWZRUN RU :$1 :LGH $UHD 1HWZRUN
capable. The ATM functions that are normally performed via the dial-up telephone system, such as customer
transactions and remote monitoring, can be performed using existing in-house communications network.
ATM transaction processing and hardware monitoring functions are performed across a shared network
medium. Ethernet is popular because it strikes a good balance between speed, cost and ease of installation.
TCP/IP C
ABLE
(CAT-5) C
ONNECTIVITY
1. If the unit is ON, enter
M
ANAGEMENT
F
UNCTIONS
> S
YSTEM
P
ARAMETERS
> S
HUT
D
OWN THE
T
ERMINAL
.
:KHQ SURPSWHG RQ WKH VFUHHQ RSHQ WKH FRQWURO SDQHO KRRG DQG WXUQ WKH SRZHU VZLWFK RQ WKH SRZHU
supply to the OFF (0) position.
2. Refer to the section on “Power and Communication”. Route the 10Base-T (CAT-5) cable through
the cabinet base cable access hole. Secure cable inside vault area and continue up to the control panel
access holes.
3. Connect the RJ-45 end of CAT-5 cable to the TCP/IP connector located on the
X2 M
AIN
B
OARD
DVVHPEO\ DV VKRZQ LQ ¿JXUH EHORZ
6HFXUH FDEOH LQWR H[LVWLQJ FDEOH KDUQHVV UXQV 5HIHU WR WKH &RQ¿JXUDWLRQ PDQXDO IRU SURJUDPPLQJ
Ethernet options.
USB P
ORTS
RJ-45 (CAT-5)
TCP/IP P
ORT