Triton RT2000 X2 Installation Manual - Manual (Page 20)

20
M
ODEL
RT2000 (X2) I
NSTALLATION
G
UIDE
A
DJUSTING
H
EIGHT
/L
EVEL OF
U
NIT
Triton Systems offers two (2) metal-constructed optional plinths w/leveling feet. The
plinths come in 2 heights: 3” (76 mm) and 6” (152 mm - shown below). Based on the
height requirement needed, you can either:
1) Raise the unit with the leveling feet installed in the cabinet (Business Hours
and Level 1) using a 1/4” (6mm) nut driver/socket.
(Caution: The leveling feet are primarily for that purpose - leveling the ATM, not to
raise the unit by more than 3/4”).
2) Construct your own plinth. A “plinth” is a platform on which the ATM rests or is
secured. This plinth enables the ATM to be installed at the required height through the
wall. If built, it must be no smaller than the base of the cabinet and must be constructed
of a material that is capable of supporting the weight of the ATM.
3) 3XUFKDVH DQ RSWLRQDO SOLQWK 5DLVH WKH XQLW E\ D ¿[HG DPRXQW ´RU ´ DQG LI
needed, adjust up using the plinths leveling feet (adjustable crescent wrench required).
Caution: Leveling feet are primarily used for leveling the ATM, not to raise the unit
by more than 3/4”.
4) “Stack” the optional plinths. Before securing two (2) plinths together, remove the
leveling feet from the top plinth.
c
Leveling feet
d
Anchor holes
e
Cabinet/Stack holes
c
d
e