Triton RT2000 X2 Installation Manual - Manual (Page 27)

27
M
ODEL
RT2000 (X2) I
NSTALLATION
G
UIDE
POWER SUPPLY CORD -
SPECIFICATIONS
For European applications, the
power supply cord must conform to
WKH IROORZLQJ VSHFL¿FDWLRQV
1. Two-conductor with Physical
Earth (PE) ground.
2. IEC 320 molded connector on
one end and molded plug on
the other end.
3. C e r t i f i e d f o r c o u n t r y o f
installation.
4. Rated minimum H05VV-F with
minimum 0.75 mm2 (except
where specific countries
require 1.0 mm2) conductors.
5. Maximum length: 3 meters.
Power Outlet Accessibility
:KHWKHU \RX DUH LQVWDOOLQJ D QHZ $& VRFNHW RXWOHW RU SODQ WR XVH DQ H[LVWLQJ
outlet to supply power to the ATM, make sure the following requirements
are met:
1. The outlet is located near the equipment.
2. AC power for the terminal should come from a dedicated source with an
isolated ground. The ATM is designed to work on an IT (Isolated-Terra)
type power system having a phase-to-phase voltage not exceeding 240
volts.
3. The outlet is easily accessible and will not be blocked once the equipment
is installed.